
Design Implementation
11
2015.05.14
UG-01145_avmm
Subscribe
Send Feedback
Completing your design includes additional steps to specify analog properties, pin assignments, and
timing constraints.
Making Pin Assignments to Assign I/O Standard to Serial Data Pins
Before running Quartus II compilation, use the Pin Planner to assign I/O standards to the pins of the
device.
1. On the Quartus II Assignments menu, select Pin Planner.
The Pin Planner appears.
2. In the Node Name column, locate the PCIe serial data pins.
3. In the I/O Standard column, double-click the right-hand corner of the box to bring up a list of
available I/O standards.
4. Select the appropriate standard from the following table.
Table 11-1: I/O Standards for HSSI Pins
Pin Type I/O Standard
HSSI REFCLK Current Mode Logic (CML), HCSL
HSSI RX Current Mode Logic (CML)
HSSI TX High Speed Differential I/O
The Quartus II software adds instance assignments to your Quartus II Settings File (*.qsf). The assignment
is in the form set_instance_assignment -name IO_STANDARD <"IO_STANDARD_NAME"> -to
<signal_name>. The *.qsf is in your synthesis directory.
Related Information
Arria 10 GX GT, and SX Device Family Pin Connection Guidelines
Recommended Reset Sequence to Avoid Link Training Issues
Successful link training can only occur after the FPGA is configured. Designs using CvP for configuration
initially load the I/O ring and periphery image. Arria 10 devices include a Nios II Hard Calibration IP
core that automatically calibrates transceivers to optimize signal quality after CvP completes and before
©
2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are
trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at www.altera.com/common/legal.html. Altera warrants performance
of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any
products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information,
product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device
specifications before relying on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
www.altera.com
101 Innovation Drive, San Jose, CA 95134
Kommentare zu diesen Handbüchern