
Clock Name
Direction
Description
ex_delay_clk Input
Extended delay measurement interface
ex_delay_reset Input
rx_lcv Output L1 debug interface
These signals are available only if you turn on Enable debug
interface in the CPRI v6.0 parameter editor.
rx_freq_alarm Output
Related Information
• CPRI v6.0 IP Core Clocking Structure on page 3-3
• CPRI v6.0 IP Core Reset Requirements on page 3-5
• CPU Interface to CPRI v6.0 IP Core Registers on page 3-35
• CPU Interface Signals on page 3-36
• Start-Up Sequence Following Reset on page 3-6
• Auto-Rate Negotiation on page 3-40
• Extended Delay Measurement on page 3-41
• Extended Delay Measurement Interface on page 3-43
CPRI v6.0 IP Core Transceiver and Transceiver Management Signals
The CPRI v6.0 IP core configures the interface to the CPRI serial link in an Altera device transceiver
channel. The IP core provides multiple interfaces for managing the transceiver. The transceiver is
configured with a Native PHY IP core and exposes many of its optional interfaces for ease of IP core
integration in your design.
Table 4-4: Transceiver and Transceiver Management Signals
Signal Name Direction Description
xcvr_cdr_refclk Input
Main transceiver clock and reset-done signals
xcvr_recovered_clk Output
xcvr_reset_tx_done Output
xcvr_reset_rx_done Output
xcvr_rxdatain
Input
CPRI link interface
xcvr_txdataout
Output
xcvr_los
Input
4-6
CPRI v6.0 IP Core Transceiver and Transceiver Management Signals
UG-01156
2014.08.18
Altera Corporation
CPRI v6.0 IP Core Signals
Send Feedback
Kommentare zu diesen Handbüchern