Altera Integer Arithmetic IP Bedienungsanleitung PDF herunterladen (Seite 50)

• The encoded input data for F0 is 14F0 (1 0100 1111 0000 in binary), as seen on the output port, q[], at

17.5 ns.

Design Example 1: Calculation of Parity Bits

Design Example 2: ALTECC_DECODER

This design example uses the ECC decoder to decode input code words of 13-bit widths to generate 8 bits

of output data. An asynchronous clear signal is also used to illustrate how the signal affects the registered

ports. This example uses the MegaWizard Plug-In Manager in the Quartus II software.

The following design files can be found in altecc_DesignExample2.zip:

• altecc_decode.qar (archived Quartus II design files)

• altecc_decode_ex_msim (ModelSim-Altera files)

Understanding the Simulation Results

The following settings are observed in this example:

• The data[] input width is set to 13 bits

• The output port, q[] has a width of 8 bits

• The asynchronous clear (aclr) signal is enabled

• Pipelining is enabled, with an output latency of 2 clock cycles. Hence, the result is seen on the q[] port

two clock cycles after the input data is available

The following figure shows the expected simulation results in the ModelSim-Altera software.

Figure 5-6: Design Example 2: Simulation Waveform for the ECC Decoder

The following sequence corresponds with the numbered items in the figure.

1. The decoder decodes the code word 14F0 at the first rising edge of the clock at 2.5 ns. In this case, the

input code word is not corrupted. The 13-bit input code word 14F0 (1 0100 1111 0000 in binary) is

decoded to generate an 8-bit output data of F0. The following table lists the arrangement of parity bits

and data bits in the code word 14F0. The prefixes P and D denote parity and data respectively.

5-12

Design Example 1: Calculation of Parity Bits

UG-01063

2014.12.19

Altera Corporation

ALTECC (Error Correction Code: Encoder/Decoder)

Send Feedback

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 156 157

Keine Kommentare

Altera Integer Arithmetic IP Bedienungsanleitung Seite 50