Altera Mentor Verification IP Altera Edition AMBA AXI4-St Bedienungsanleitung PDF herunterladen (Seite 44)

Mentor Verification IP AE AMBA AXI4-Stream User Guide, V10.3

SystemVerilog Slave BFM

Slave BFM Configuration

April 2014

Slave BFM Configuration

The slave BFM supports the full range of signals defined for the AMBA AXI4-Stream Protocol

Specification. It has parameters that you use to configure the widths of the data and ID signals,

and transaction fields to configure timeout factors, setup and hold times, and so on.

You can change the data and ID signal widths from their default settings by assigning them new

values, usually in the top-level module of the test bench. These new values are then passed into

the slave BFM using a parameter port list of the slave BFM module. Example 4-1 shows the

slave BFM with the data and ID signal widths defined in module top() and passed in to the slave

BFM mgc_axi4stream_slave parameter port list.

Example 4-1. Slave BFM Configuration

module top ();

parameter AXI4STREAM_ID_WIDTH = 18;

parameter AXI4STREAM_USER_WIDTH = 4;

parameter AXI4STREAM_DEST_WIDTH = 4;

parameter AXI4STREAM_DATA_WIDTH = 32;

mgc_axi4stream_slave #(AXI4STREAM_ID_WIDTH, AXI4STREAM_USER_WIDTH,

AXI4STREAM_DEST_WIDTH, AXI4STREAM_DATA_WIDTH) bfm_slave(....);

Note

In the Example 4-1 code extract, the mgc_axi4stream_slave is the slave BFM interface.

Table 4-1 lists the parameter names for the data and ID signals and their default values.

Table 4-1. Slave BFM Signal Width Parameters

Signal Width Parameter Description

AXI4_ID_WIDTH ID signal width in bits. This applies to the TID signal.

Refer to the AMBA AXI4-Stream Protocol Specification

for more details. Default: 18.

AXI4_USER_WIDTH User data signal width in bits. This applies to the TUSER

signal. Refer to the AMBA AXI4-Stream Protocol

Specification for more details. Default: 8.

AXI4_DEST_WIDTH Destination routing signal width in bits. This applies to

the TDEST signal. Refer to the AMBA AXI4-Stream

Protocol Specification for more details. Default: 18.

AXI4_DATA_WIDTH Data signal width in bits. This applies to the TDATA

signal. Refer to the AMBA AXI4-Stream Protocol

Specification for more details. Default: 1024.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 230 231

Keine Kommentare

Altera Mentor Verification IP Altera Edition AMBA AXI4-St Bedienungsanleitung Seite 44