Altera FIR Compiler Bedienungsanleitung PDF herunterladen (Seite 63)

Chapter 4: Functional Description 4–21

Timing Diagrams

These timing diagrams also apply to an MCV single cycle filter. An interpolation-by-2

filter produces two output data for each input data it receives. As seen from the

figures, a new output is produced every cycle. This means that new input data is

required every other cycle.

This behavior can be observed easily when the flow of data is controlled by the

ast_sink_valid signal as in Figure 4–19.

Figure 4–21 shows the timing diagram for a three channel, interpolation-by-2 filter

with a Parallel or MCV single cycle architecture illustrating the additional start of

packet and end of packet signals.

The timing diagrams for Serial, Multibit serial, and MCV multicycle filters would be

similar to Figure 4–17 and Figure 4–18. For an MCV filter with a Clocks to Compute

value of N, and interpolation factor M, new input data is required every N×M clock

cycles and a new output would be produced every M clock cycles.

Decimation Filter Timing Diagrams

In a decimation-by-M filter, for every M input data, one output will be produced.

Figure 4–22 on page 4–22 shows that for a Parallel or MCV (single cycle) decimation-

by-2 filter, new input data is taken each clock cycle and new output data is produced

every other clock cycle.

Figure 4–20. Single Channel, Interpolation-by-2 (Parallel, MCV Single Cycle), ast_sink_ready Control

Figure 4–21. Three Channel, Interpolation-by-2 (Parallel, MCV Single Cycle)

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 75 76

Keine Kommentare

Altera FIR Compiler Bedienungsanleitung Seite 63