Altera PCI Development Kit, Cyclone II Edition Getting St Bedienungsanleitung PDF herunterladen (Seite 11)

Altera Corporation Core Version a.b.c variable 2–1

May 2005 Preliminary

2. Getting Started

Introduction

The PCI Development Kit, Cyclone

™

II Edition is a complete PCI and

PCI-X prototyping and testing kit, based on the Cyclone II device. With

this kit, you can perform various PCI transactions between the board and

the host PC, as well as configure the board with either the

factory-programmed or user-programmable design.

In addition to providing a PCI/PCI-X form factor development board,

the kit also includes all of the hardware and software development tools,

as well as the documentation and accessories you need to begin

developing PCI systems using the Cyclone II device.

This user guide familiarizes you with the contents of the kit and walks

you through setting up a PCI development environment.

In this guide, you will do the following:

■ Inspect the contents of the kit

■ Install the development tools software

■ Set up licensing

■ Connect the cables to the board and your PC

■ Test the board using the factory-programmed design

■ Install the board in your PC

■ Perform example PCI transactions

■ Configure the Cyclone II device

■ Use the board as a prototyping platform

Before You

Begin

Before using the kit or installing the software, be sure to check the kit’s

contents and inspect the board to verify that you received all of the items

listed below. If any of the items are missing, contact Altera

before you

proceed. You should also verify that your computer’s hardware and

software meet the kit’s system requirements.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Keine Kommentare

Altera PCI Development Kit, Cyclone II Edition Getting St Bedienungsanleitung Seite 11