Altera High-Speed Development Kit, Stratix GX Edition Bedienungsanleitung PDF herunterladen (Seite 72)

5–28 Quartus II Version 3.0 Altera Corporation

Nios-Based Tests High-Speed Development Kit, Stratix GX Edition User Guide

-----------------------------------------

Reinitializing...

[lan91c111] nr_lan91c111_reset: chip id = SMC91C11xFD

[lan91c111] r_lan91c111_detect_phy: found lan83C183 (lan91C111 internal)

[lan91c111] r_lan91c111_init_phy: phy negotiation timed out

[lan91c111] r_lan91c111_init_phy: 10bt

[lan91c111] r_lan91c111_init_phy: half duplex

[dhcp] 1 timing out

[dhcp] 2 timing out

[dhcp] 3 timing out

[dhcp] 4 timing out

[dhcp] 5 timing out

[dhcp] 6 timing out

[dhcp] 7 timing out

[dhcp] 8 timing out

[dhcp] 9 timing out

[dhcp] 10 timing out

[dhcp] 11 timing out

[dhcp] 12 timing out

12. Press reset (Stratix_PB_0) to stop the test.

13. Press Ctrl + C in the shell to exit the test program.

14. If this test passes, write the word “PASS” in the column under

Stratix in the row Stratix Nios Ethernet in the worksheet.

15. Start the on-board flash memory test and EPC16 flash memory test

by typing nr ft.srec r. This command starts the writing and

reading from the on-board flash memory device. Observe the shell

for the proper response. See Figure 5–22.

Figure 5–22. Flash & EPC16 Memory Tests

[SOPC Builder]$ nr ft.srec

nios-run: Ready to download ft.srec over COM1: at 115200 bps

nios-run: Downloading...........................................................

................................................................................

.....................

nios-run: Terminal mode (Control-C exits)

-----------------------------------------

Erasing Flash Sector for EPC16 One

Erasing Flash Sector for EPC16 Two

Erasing Flash Sector for AMD

Writing 512 shorts to all Flash interfaces

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 139 140

Keine Kommentare

Altera High-Speed Development Kit, Stratix GX Edition Bedienungsanleitung Seite 72