
Resource Utilization and Performance
The ALTUFM IP core is only available for MAX II and MAX V devices. Resource usage is reported with
different interface options. Configuration mode settings described in the following tables are available in
the parameter editor.
Table 1: ALTUFM_SPI Resource Usage
UFM BlocksLogic ElementConfiguration Mode
(3)
Optimization
(2)
Access Mode
(1)
1147Base modeBalancedRead/write
172Base modeBalancedRead only
1134Extended modeBalancedRead/write
140Extended modeBalancedRead only
Notes to Table 1–1:
1. Choose the access mode option to configure the UFM to the required mode of operation. Choose a design
implementation that balances high performance with minimal logic usage. The balanced optimization
logic option is set in Analysis and Synthesis settings (Assignments menu).
2. Choose the configure mode to set the mode of access with SPI interface to the UFM block. Set this option
to Base Mode or Extended Mode depending on the widths of the address and data buses.
Table 2: ALTUFM_PARALLEL Resource Usage
UFM BlocksLogic ElementData WidthAddress WidthOptimization
(2)
Access Mode
(1)
188169BalancedRead/write
169169BalancedRead only
Notes to Table 1–2:
1. Choose the access mode option to configure the UFM to the required mode of operation.
2. Choose a design implementation that balances high performance with minimal logic usage. The balanced
optimization logic option is set in Analysis and Synthesis settings (Assignments menu).
Table 3: ALTUFM_NONE Resource Usage
UFM BlocksOptimization
(1)
Logic Elements
1Balanced3
Note to Table 1–3:
1. Choose a design implementation that balances high performance with minimal logic usage. The balanced
optimization logic option is set in Analysis and Synthesis settings (Assignments menu).
. Choose the Access Mode option to configure the UFM to the required mode of operation.
Altera User Flash Memory (ALTUFM) IP Core User Guide
Altera Corporation
Send Feedback
UG-040105
Resource Utilization and Performance
2
2014.08.18
Kommentare zu diesen Handbüchern