Altera Cyclone V GT FPGA Bedienungsanleitung PDF herunterladen (Seite 11)

Chapter 3: Software Installation 3–3

Installing the USB-Blaster II Driver

September 2014 Altera Corporation Cyclone V GT FPGA Development Kit

User Guide

The installation program creates the Cyclone V GT FPGA Development Kit directory

structure shown in Figure 3–1.

Table 3–1 lists the file directory names and a description of their contents.

Installing the USB-Blaster II Driver

The Cyclone V GT FPGA development board includes integrated USB-Blaster

circuitry for FPGA programming. However, for the host computer and board to

communicate, you must install the On-Board USB-Blaster II driver on the host

computer.

f For installation instructions for the On-Board USB-Blaster II driver, refer to the Cable

and Adapter Drivers Information page of the Altera website.

Figure 3–1. Cyclone V GT FPGA Development Kit Installed Directory Structure

(1)

Note to Figure 3–1:

(1) Early-release versions might have slightly different directory names.

documents

board_design_files

The default Windows installation directory is C:\altera\

examples

factory_recovery

demos

kits

cycloneVGT_5cgtfd9ef35_fpga

Table 3–1. Installed Directory Contents

Directory Name Description of Contents

board_design_files

Contains schematic, layout, assembly, and bill of material board design files. Use these files as a

starting point for a new prototype board design.

demos Contains demonstration applications.

documents Contains the kit documentation.

examples Contains the sample design files for the Cyclone V GT FPGA Development Kit.

factory_recovery

Contains the original data programmed onto the board before shipment. Use this data to restore

the board with its original factory contents.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 49 50

Keine Kommentare

Altera Cyclone V GT FPGA Bedienungsanleitung Seite 11