Altera Arria V Avalon-MM Bedienungsanleitung Seite 52
- Seite / 166
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Register Width Direction Description
cfg_slot_ctrl
16 Output cfg_slot_ctrl[15:0] is the Slot Status of the PCI
Express capability structure. This register is only
available in Root Port mode.
cfg_link_ctrl
16 Output cfg_link_ctrl[15:0]is the primary Link Control
of the PCI Express capability structure.
For Gen2 operation, you must write a 1’b1 to the
Retrain Link bit (Bit[5] of the cfg_link_ctrl) of
the Root Port to initiate retraining to a higher data
rate after the initial link training to Gen1 L0 state.
Retraining directs the LTSSM to the Recovery state.
Retraining to a higher data rate is not automatic for
the Arria V Hard IP for PCI Express IP Core even if
both devices on the link are capable of a higher data
rate.
cfg_link_ctrl2
16 Output cfg_link_ctrl2[31:16] is the secondary Link
Control register of the PCI Express capability
structure for Gen2 operation.
When tl_cfg_addr=4'b0010, tl_cfg_ctl returns
the primary and secondary Link Control registers,
{ {cfg_link_ctrl[15:0], cfg_link_
ctrl2[15:0]}. The primary Link Status register
contents are available on tl_cfg_sts[46:31].
For Gen1 variants, the link bandwidth notification
bit is always set to 0. For Gen2 variants, this bit is
set to 1.
cfg_prm_cmd_func<n>
16 Output Base/Primary Command register for the PCI
Configuration Space.
cfg_root_ctrl
8 Output Root control and status register of the PCI Express
capability. This register is only available in Root
Port mode.
cfg_sec_ctrl
16 Output Secondary bus Control and Status register of the
PCI Express capability. This register is available
only in Root Port mode.
cfg_secbus
8 Output Secondary bus number. This register is available
only in Root Port mode.
cfg_subbus
8 Output Subordinate bus number. This register is available
only in Root Port mode.
4-22
Configuration Space Register Access
UG-01105_avmm
2014.12.15
Altera Corporation
Interfaces and Signal Descriptions
Send Feedback
- User Guide 1
- Datasheet 2
- Features 3
- Release Information 6
- Device Family Support 6
- Altera FPGA 7
- IP Core Verification 9
- Debug Features 9
- Recommended Speed Grades 10
- Hard IP for PCI Express 12
- Running Qsys 13
- Generating the Example Design 14
- Programming a Device 18
- Quartus II Programmer 19
- Parameter Settings 20
- Parameter Value Description 21
- Device Capabilities 23
- Error Reporting 24
- Link Capabilities 25
- MSI and MSI-X Capabilities 25
- Power Management 27
- Subscribe 31
- RX Avalon-MM Master Signals 33
- Clock Signals 38
- Reset Signals 38
- Signal Direction Description 39
- Hard IP Status 40
- IntxReq_i 44
- IntAck_o 44
- Hard IP Status Extension 46
- Field and Bit Map 54
- 0134678951 54
- Serial Interface Signals 55
- 9 Ch 18 Ch 56
- Variant Data CMU Clock 57
- PIPE Interface Signals 58
- Test Signals 62
- Registers 63
- Altera-Defined VSEC Registers 71
- CvP Registers 72
- Address Range Register 76
- Bit Name Access Description 77
- Bits Name Access Description 78
- PCI Express Mailbox Registers 79
- Avalon-MM Mailbox Registers 83
- Address Name Access 84
- Description 84
- Byte Offset 84
- Register Dir Description 84
- Sending a Write TLP 90
- Root Port TLP Data Registers 92
- Bits Register Description 95
- Reset and Clocks 98
- Example Design 99
- UG-01105_avmm 100
- 2014.12.15 100
- Clock Domains 102
- Data Rate Frequency 103
- Related Information 103
- Clock Summary 104
- Interrupts for Endpoints 105
- MSI/MSI‑X Support 107
- Qsys System 108
- Error Handling 109
- Physical Layer Errors 110
- Data Link Layer Errors 110
- Transaction Layer Errors 111
- Error Type Description 112
- Status Bit Conditions 115
- IP Core Architecture 117
- Hard IP for PCI Express 118
- Clocks and Reset 119
- Transceiver Reconfiguration 119
- Interrupts 119
- Data Link Layer 120
- Altera Corporation 121
- Send Feedback 121
- Physical Layer 122
- TX Packets 123
- Avalon‑MM Bridge TLPs 127
- Byte Enable Value Description 128
- PCI Express Avalon-MM Bridge 130
- RX Block 136
- Avalon-MM RX Master Block 136
- TX Block 137
- Interrupt Handler Block 137
- Design Implementation 139
- Making Pin Assignments 140
- Optional Features 141
- ECRC on the RX Path 142
- ECRC on the TX Path 143
- Enable PLL calibration 145
- Debugging 148
- Setting Up Simulation 149
- Use Third-Party PCIe Analyzer 150
- BIOS Enumeration Issues 151
- Address[31:2] 152
- Figure A-6: I/O Read Request 154
- 7 6 5 4 3 2 1 0 158
- Core Config 8 4 1 158
- Additional Information 160
- Date Version Changes Made 161
- How to Contact Altera 163
- Typographic Conventions 164
- Visual Cue Meaning 165
Verwandte Produkte und Handbücher für Messgeräte Altera Arria V Avalon-MM
Messgeräte Altera DDR3 SDRAM High-Performance Controller and ALTMEMP Bedienungsanleitung
(10 Seiten)
(10 Seiten)
Messgeräte Altera DDR SDRAM High-Performance Controllers and ALTMEMP Bedienungsanleitung
(140 Seiten)
(140 Seiten)
Messgeräte Altera Floating-Point Bedienungsanleitung
(157 Seiten)
(157 Seiten)
Messgeräte Altera JESD204B IP Bedienungsanleitung
(158 Seiten)
(158 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.077 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern