search

Altera Arria II GX FPGA Development Board Bedienungsanleitung Seite 25

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 64
  • Inhaltsverzeichnis
  • LESEZEICHEN
    • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 24
Chapter 2: Board Components 2–17
Configuration, Status, and Setup Elements
February 2011 Altera Corporation Arria II GX FPGA Development Board Reference Manual
FPGA Programming over External USB-Blaster
The JTAG programming header provides another method for configuring the FPGA
(U19) using an external USB-Blaster device with the Quartus II Programmer running
on a PC. The external USB-Blaster is connected to the board through the JTAG
connector (J5). Install a shunt onto the JTAG chain header (J9) pins 1 and 2 to remove
the MAX II CPLD device from the JTAG chain so that the FPGA is the only device on
the JTAG chain.
f For more information on the following topics, refer to the respective documents:
■ Board Update Portal, refer to the Arria II GX FPGA Development Kit User Guide.
■ PFL design, refer to the Arria II GX FPGA Development Kit User Guide.
■ PFL Megafunction, refer to the Parallel Flash Loader Megafunction User Guide.
Status Elements
The development board includes status LEDs. This section describes the status
elements.
Table 2–11 lists the LED board references, names, and functional descriptions.
Table 2–11. Board-Specific LEDs (Part 1 of 2)
Board Reference LED Name Description
D18 Power Blue LED. Illuminates when 2.5 V power is active.
D14 CONF DONE
Green LED. Illuminates when the FPGA is successfully configured. Driven by the
MAX II CPLD EPM2210 System Controller.
D15 Loading
Green LED. Illuminates when the MAX II CPLD EPM2210 System Controller is
actively configuring the FPGA. Driven by the MAX II CPLD EPM2210 System
Controller wire-OR'd with the embedded USB-Blaster CPLD.
D16 Error
Red LED. Illuminates when the MAX II CPLD EPM2210 System Controller fails to
configure the FPGA. Driven by the MAX II CPLD EPM2210 System Controller.
D11, D12, D13 CONFIG[2:0]
Green LEDs. Illuminates to indicate which hardware page loads from flash
memory.
D19 ENET TX
Green LED. Illuminates to indicate Ethernet PHY transmit activity. Driven by the
Marvell 88E1111 PHY.
D20 ENET RX
Green LED. Illuminates to indicate Ethernet PHY receive activity. Driven by the
Marvell 88E1111 PHY.
D23 10
Green LED. Illuminates to indicate Ethernet linked at 10 Mbps connection speed.
Driven by the Marvell 88E1111 PHY.
D22 100
Green LED. Illuminates to indicate Ethernet linked at 100 Mbps connection speed.
Driven by the Marvell 88E1111 PHY.
D21 1000
Green LED. Illuminates to indicate Ethernet linked at 1000 Mbps connection speed.
Driven by the Marvell 88E1111 PHY.
D6
HSMC Port A
Present
Green LED. Illuminates when HSMC port A has a board or cable plugged-in such
that pin 160 becomes grounded. Driven by the add-in card.
D1
HSMC Port B
Present
Green LED. Illuminates when HSMC port B has a board or cable plugged-in such
that pin 160 becomes grounded. Driven by the add-in card.
D24 PCIe x1 Green LED. Configure this LED to display the PCI Express link width x1.
Seitenansicht 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare
Verwandte Produkte und Handbücher für Messgeräte Altera Arria II GX FPGA Development Board
Messgeräte Altera 100G Development Kit, Stratix V GX Edition Bedienungsanleitung   (76 Seiten)
Messgeräte Altera Arria II GX FPGA Development Board, 6G Edition Bedienungsanleitung   (62 Seiten)
Messgeräte Altera Cyclone V E FPGA Development Board Bedienungsanleitung   (56 Seiten)
Messgeräte Altera Cyclone IV GX Transceiver Starter Board Bedienungsanleitung   (40 Seiten)
Messgeräte Altera Cyclone V SoC Development Board Bedienungsanleitung   (68 Seiten)
Messgeräte Altera Video and Image Processing Suite Bedienungsanleitung   (310 Seiten)
Messgeräte Altera MAX V CPLD Development Board Bedienungsanleitung   (24 Seiten)
Messgeräte Altera DSP Development Kit, Stratix V Edition Bedienungsanleitung   (74 Seiten)
Messgeräte Altera SDI HSMC Bedienungsanleitung   (36 Seiten)
Messgeräte Altera SDC and TimeQuest API Bedienungsanleitung   (168 Seiten)
Messgeräte Altera Stratix IV GX FPGA Development Board Bedienungsanleitung   (78 Seiten)
Messgeräte Altera Stratix IV E FPGA Development Board Bedienungsanleitung   (72 Seiten)
Messgeräte Altera Transceiver Signal Integrity Development Kit, Stra Bedienungsanleitung   (42 Seiten)
Messgeräte Altera Transceiver Signal Integrity Development Kit, Stra Bedienungsanleitung   (58 Seiten)
Messgeräte Altera Arria GX Development Board Bedienungsanleitung   (42 Seiten)
Messgeräte Altera Arria V GT FPGA Development Board Bedienungsanleitung   (86 Seiten)
Messgeräte Altera Arria V GX FPGA Development Board Bedienungsanleitung   (90 Seiten)
Messgeräte Altera Arria V GX Starter Board Bedienungsanleitung   (62 Seiten)
Messgeräte Altera Quartus II Scripting Bedienungsanleitung   (634 Seiten)
Messgeräte Altera Arria V SoC Development Board Bedienungsanleitung   (70 Seiten)
  • Mobile One CheckVideo Airfonix Fat-bagger Wega
  • Oreck Dampfreiniger JVC Kassettenrekorder HP All-in-One-Arbeitsstation Hanna Instruments Mess- und Layoutwerkzeuge Sebo Nein
  • Yamaha RX-A1000 Samsung HT-X200 Scientific-atlanta 8300HDC Avallon APAC100W
  • LG SJ4 Bedienungsanleitung Acer Aspire V3-112P Bedienungsanleitung Samsung 150N Bedienungsanleitung Sony ICD-V21 Bedienungsanleitung Eurotherm 3200 Bedienungsanleitung