Altera Cyclone V E FPGA Bedienungsanleitung PDF herunterladen (Seite 10)

3–2 Chapter 3: Software Installation

Installing the USB-Blaster II Driver

Cyclone V E FPGA Development Kit December 2014 Altera Corporation

User Guide

The installation program creates the directory structure shown in Figure 3–1.

Table 3–1 lists the file directory names and a description of their contents.

Installing the USB-Blaster II Driver

The Cyclone V E FPGA development board includes integrated USB-Blaster circuitry

for FPGA programming. However, for the host computer and board to communicate,

you must install the On-Board USB-Blaster II driver on the host computer.

f Installation instructions for the On-Board USB-Blaster II driver for your operating

system are available on the Altera website. On the Altera Programming Cable Driver

Information page of the Altera website, locate the table entry for your configuration

and click the link to access the instructions.

Figure 3–1. Cyclone V E FPGA Development Kit Installed Directory Structure

(1)

Note to Figure 3–1:

(1) Early-release versions might have slightly different directory names.

documents

board_design_files

The default Windows installation directory is C:\altera\

examples

factory_recovery

demos

kits

cycloneVE_5cefa7f31_fpga

Table 3–1. Installed Directory Contents

Directory Name Description of Contents

board_design_files

Contains schematic, layout, assembly, and bill of material board design files. Use these files as a

starting point for a new prototype board design.

demos Contains demonstration applications, if available.

documents Contains the kit documentation.

examples Contains the sample design files for the Cyclone V E FPGA Development Kit.

factory_recovery

Contains the original data programmed onto the board before shipment. Use this data to restore

the board with its original factory contents.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Keine Kommentare

Altera Cyclone V E FPGA Bedienungsanleitung Seite 10