Altera Cyclone III LS FPGA Bedienungsanleitung Seite 14

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 42
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 13
4–2 Chapter 4: Development Board Setup
Factory Default Switch Settings
Cyclone III LS FPGA Development Kit User Guide © October 2009 Altera Corporation
Factory Default Switch Settings
This section shows the factory switch settings for the Cyclone III LS FPGA
development board. Figure 4–1 shows the switch bank locations and the default
position of each switch.
To restore the switches to their factory default settings, perform the following steps:
1. Set DIP switch bank (S7) to match T
able 4–1 and Figure 4–1.
2. Set DIP switch bank (SW2) to match Table 4–2 and Figure 4–1.
Figure 4–1. Switch Locations and Default Settings on the FPGA Development Board
Table 4–1. S7 Dip Switch Settings
Switch Position
1On
2On
3On
4On
Table 4–2. SW2 Dip Switch Settings
Switch Position
1On
2On
3On
4On
5Off
6On
7Off
8Off
SW2
Board Settings
DIP Switch
OFF = 1
ON = 0
S7
User
DIP Switch
OFF = 1
ON = 0
J11
JTAG Control Jumpers
12345678
OPEN
J12
432
1
ON
(not installed)J18
LCD SEL
E P3CLS200F780
(not installed)
(not installed)
(not installed)
(installed)
Seitenansicht 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare